Selecting Channel For The Receiver And Transmitter; Using The Pt-850Bc Body-Pack Transmitter - Optimus US-8001DC Manual De Instalación Y Funcionamiento

US-8001DC
Wireless Receiver

5.2 Selecting channel for the receiver and transmitter

Use the supplied screwdriver to select a desired channel for the receiver handheld transmitter or
body-pack transmitter. Both receiver and transmitter are pre-programmed with 16 channels (Figure
8).
Figure 8
Then, with the UP/DOWN button, select the channel of receiver the same as the transmitter,
please make sure the receiver channel matches that of the transmitter.
When two or more transmitters and receivers are being used in the same location, they must be
set up to use different channels. If existing channel is being interfered, please change to non-
interference channel.

5.3 Using the PT-850BC body-pack transmitter

On the rear panel of PT-850BC body-back transmitter, equipped the AF level control. Use the
supplied plastic stick to adjust a proper level (Figure 9).
The carry case allows the PT-850BC to be attached on performer's belt, place the antenna towards
the back of his body. The Velcro tag ensures tight fixing and less hindrance during performance.
Wind the Velcro tag around the belt and fix it (Figure 10).
Figure 9 Figure 10
US-8001DC Version 1.0 Page 7 of 9