Reset To Factory Defaults; System Operation; Lock; Unlock - Leviton 41920-CP8 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

41920-CP8

Reset to Factory Defaults

1. Press and hold button 1 until the blue button light goes out
2. Press and hold button 4 (button 1 will also light up) until all the Control Panel buttons light up
3. Press the following Control Panel buttons in order 5-4-2-6-1-7 (6 digit code)
4. All buttons should now flash indicating that the Control Panel is ready to restore to factory
defaults
NOTE: To exit without resetting, allow the unit to time-out after 60 seconds at this point
5. Press and hold button 8 until all the buttons go dark
6. The Control Panel has now been set to factory defaults

System Operation

Once the system is setup and programmed the Control Panel allows users to power on/off a display
device, turn the volume up and down and switch between the three inputs to the Autoswitching
Wallplate. Another feature is the ability to lock the Control Panel to keep unauthorized users from
operating the system.

Lock

1. To lock the Control Panel, press and hold the lock button (button 8). The button will light up.
Hold the button until the Control Panel button light goes out
2. The Control Panel is now locked

Unlock

1. To unlock the Control Panel, press the Control Panel buttons in the following sequence; 1-2-3-
4
2. The buttons will light up as they are pressed. Once the sequence has been pressed the
Control Panel will be unlocked
1
5
2
6
3
7
4
8
11
DI-060-41920-25A

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido