Advice Regarding The First Wash Cycle; Technical Data; Ecodesign Regulation - Hotpoint Ariston LTF 11H132 Manual De Instrucciones

*
Anti-condensation strip
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add only then approximately 1 kg of salt
(see chapter entitled Rinse aid and refined salt)
may overflow: this is normal and is not a cause for concern.
Select the water hardness value
aid and refined salt).
- After the salt has been poured into
the machine, the LOW SALT indicator light
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.

Technical data

width 59.5 cm
height 82 cm
Dimensions
depth 57 cm
14 standard place-settings
Capacity
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
Water supply
7,25 – 145 psi
pressure
See appliance data plate
Power supply voltage
See appliance data plate
Total absorbed power
See appliance data plate
Fuse
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EC (WEEE)

ECODESIGN REGULATION

ECO wash cycle is the standard cycle to which the energy label data refers; this cycle can be used to wash crockery with a normal
soil level and is the most efficient in terms of energy and water consumption for this type of crockery. To reduce consumption even
further, only run the dishwasher when it is full.
Standby consumption: Left-on mode consumption: 5 W – Off mode consumption: 0,5 W
Consumption data table for the main cycles
Standard conditions
Energy consumption
(kWh/cycle)
INTENSIVE 1,50
1,20
NORMAL
*
Cycle data refers to the values recorded in a laboratory, in accordance with European standard EN 50242.
**
Data is obtained by recording values when the appliance is operational and loaded with user crockery.
. The water
(see chapter entitled Rinse
*
switches off.
*
Water consumption Duration
(l/cycle) (min/cycle)
15 150
15 120
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
**
User conditions
Energy consumption Water consumption
(kWh/cycle) (l/cycle)
1,25 14
1,00 14
(depending on the
EN
.
Duration (min/
cycle)
135
110
5