Pride Mobility MV600 Manual Del Usaurio página 14

Main Circuit Breaker (Reset Button)
When the voltage in the batteries becomes low or your vehicle
is heavily strained because of excessive loads, the main circuit
breaker may trip to protect the motor and electronics from
damage. When the breaker trips, the entire electrical system
shuts down. See fi gure 8.
 The reset button pops out when the breaker trips.
 Allow a minute or so for the electronics to "rest."
 Push in the reset button to reset the breaker.
 If the breaker trips frequently, you may need to charge the
batteries more often or have your authorized dealer perform
a load test on the batteries.
 If the main circuit breaker trips repeatedly, see your authorized
dealer for service.
NOTICE: If you are preparing the vehicle for transport or service, or if there is a situation that requires you
to manually shut down the electrical system, press the manual shut-off button on the circuit breaker. This will
cut all power to the vehicle.
SECURING THE VEHICLE
Always secure the vehicle in a forward-facing position in the motor vehicle. Attach the four tie-down straps to the
designated securement points. See fi gures 9. Tighten the straps to suffi ciently remove all slack. Never attach tie-
downs to adjustable, moving or removable parts of the vehicle such as armrests, shrouds and wheels. These items
should be removed. Position the anchor points for the rear tie-down straps directly behind the rear securement
points on the vehicle. The front tie-down straps should anchor to fl oor points that are spaced wider than the vehicle
to provide increased lateral stability.
WARNING! Ensure vehicles are properly secured to the motor vehicle during transport. Vehicles
that are not properly secured can become a hazard to the user and to other motor vehicle
passengers in the event of a crash, sudden stopping, or swerving, as the vehicle could tip or
slide out of place. Do not secure a vehicle by any of its removable parts such as armrests, seat,
basket, accessory brackets, etc.
1
Figure 9. Securement Points (Identifi ed with black dots)
14
I I . Y O U R V E H I C L E
IDENTIFICATION KEY
1. FRONT SECUREMENT POINTS
2. REAR SECUREMENT POINTS
IDENTIFICATION KEY
1. RESET LEVER
2. MANUAL SHUT-OFF BUTTON
1
Figure 8. Main Circuit Breaker (Reset Button)
2
2
MV600