GB
• less than 6 m away from a fireplace or
wood-burning stove where combustion
fumes could cause untimely alarms,
• in premises where cooking fumes and
steam could result in untimely triggering,
• in premises where there is a risk of
condensation or humidity (bathrooms,
laundries, etc.),
• at the top of pointed (A-shaped) ceilings as
an air pocket at this point could prevent
smoke from reaching the detector (Fig. 2).
Mounting examples:
Fig. 1
Recommended
location
Acceptable
location
Fig. 2
d > 50 cm
d > 50 cm
4.2 testing the radio link
at the chosen location
CAution: the control panel must be in
installation mode in order to effect this test
(see familiarisation).
1. Hold down the detector programming key
0 or the test key until the integral alarm
sounds:
• correct: the control panel confirms the
radio link with a voice message "beep,
fire detector n° X",
• incorrect: no voice message at all, go
back to the smoke detector at the control
panel.
2. Put the control panel back in user mode
and press:
engineer installer code
40