Safety Instructions - Atlantis A11-NVR1600 Guia De Inicio Rapido

Copyright Statement
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by
any means, whether electronic, mechanical, photocopying, recording or otherwise without the prior writing
of the publisher. Windows™ 98SE/2000/ME/XP/VISTA are trademarks of Microsoft
trademark of Intel. All copyright reserved.The Atlantis logo is a registered trademark of Atlantis. All other
names mentioned mat be trademarks or registered trademarks of their respective owners. Subject to change
without notice. No liability for technical errors and/or omissions.
CE/EMC Restriction of Liability
The product described in this handbook was designed, produced and approved according to the EMC-
regulations and is certified to be within EMC limitations.
If the product is used in an uncertified PC, the manufacturer undertakes no warranty in respect to the EMC
limits. The described product in this handbook was constructed, produced and certified so that the measured
values are within EMC limitations. In practice and under special circumstances, it may be possible, that the
product may be outside of the given limits if it is used in a PC that is not produced under EMC certification.
It is also possible in certain cases and under special circumstances, which the given EMC peak values will
become out of tolerance. In these cases, the user himself is responsible for compliance with the EMC limits.
In a domestic environment, this product may cause radio interference, in which case the user may be required
to take adequate measures.s
Declaration of Conformity (
Product complies with 2014/30/CE & 2014/35/CE Directives. The declaration in full version and the technical
documentations are available at our headquarters. Keep the packaging for future references. CE and WEEE
logo should be not fully compliant with minimum dimensions requirement to European Directive due to limited
area.

SAFETY INSTRUCTIONS

 Electric shock can be avoided. Follow the recommended practices listed below. Faulty installation, improper
grounding, and incorrect operation and maintenance of electrical equipment are always sources of danger.
 Do Not try to install equipment outdoor, when the wind and rain is strong.
 Do Not install or remove equipment outdoor ,when the weather is raining.
 Do Not try to install or operate any equipment , when the thunderstorm happened.
 Always Ground all electrical equipment and the work platform.
 Prevent accidental electrical shocks. Connect power source, control cabinets, and work platform to an
approved electrical ground.
 Always use the correct cable size.
 Sustained overloading will cause cable failure and result in possible electrical shock or fire hazard. Work
cable should be the same rating as the torch cable or factory .
 Always keep cables and connectors in good condition.
 Improper or worn electrical connections can cause short circuits and can increase the chance of an electrical
shock. Do not use worn, damaged, or bare cables.
 Always avoid open-circuit voltage.
 The added voltages increase the severity of the shock hazard.
 Always wear insulated gloves while you adjust equipments.
 Power should be shut off and insulated gloves should be worn when making any equipment adjustment to
assure shock protection.
 Always wear protective clothing such as long sleeve shorts while you are installing or removing equipments.
 Always Wear high, snug fitting shoes.
 Always Wear clean clothes without grease or oil.
 Do not wear clothing that has been stained with oil and grease. It may burn if ignited by the heat of the
arc.
 Protect neighboring workers from exposure to arc radiation.
 Always Wear long trousers or jeans while you are installing or removing equipments.
)
27
ENG
® Corp. Pentium is