Maintenance; How To Store The Steam Cleaner - Lavor SKYVAP Manual Del Usario

EN
• Lay the scrubbing brush (14) in the middle of
the cloth.
• Push the cloth holding spring clamps (15) and
keep them pressed.
• Put two corners of the cloth under the spring
clamps (15) from behind.
• Now put the front half of the cloth under the
spring clamps (15) and release them.
Applying the cloth to the triangular
brush
• Place the triangular brush (22) on the cloth (24)
• Wrap the cloth around the triangular brush (see
figure).
Fitting the small brush
NOTE:
• The small brush (21) must be used only together
with the bent nozzle (20).
- Fit the small brush into the bent nozzle.
- Fit the bent nozzle into the pipe (17) or into the
steam nozzle handle (19).
Cleaning window glass
(fig. G)
•ATTENTION! If external temperatures are
around the freezing-point, the window glass
can be slightly sprayed with steam at a distance
of 20 cm, at least.
• After that, you can treat the whole glass
surface with steam to offset sudden changes in
temperature and to avoid tensile stress on the
glass surface.
• Sudden changes in temperature between glass
and steam can break the glass.
Installing the glass cleaner - use
(7) Optional (fig 1-2)
• Fit the window cleaner into the steam nozzle
handle (19) or into the extension pipe (17) until
the spring button (18) snaps into place.
NOTE:
• The regulator (12) features 5 adjustable
positions: on position 1, steam quantity is
52
minimum, whereas in position 5 it is maximum.
Do not use position 1 for more than 5 minutes.
• Very dirty windows must be cleaned first with
the small (22) or big (14) brush and the cloth
(23 or 24).
• Then, clean the window with the window
cleaner.
• After cleaning, remove dirt from the rubber
head of the window cleaner with a clean cloth.
Only a clean and well stretched band allows a
perfect cleaning of the window without leaving
stripes.
- Spray steam onto the window starting at the
top and moving downward (fig. 1) by placing
the regulator on position 3.
- Remove dirt with the rubber sponge (fig. 2).
- Lay the wiper rubber band on a part of the
window treated with steam (fig. 3).
----------
(7) Optional
- Lay the wiper rubber band on a part of the
window treated with steam.
> MAINTENANCE
DANGER!
• Before any maintenance or cleaning,
• Switch off
• Unplug the machine.
• Do not empty the machine as long as there is
hot water inside the boiler.
• In order to avoid formation of limescale, it is
recommended to fill the boiler with water rinse
and empty it once a month.
• If the machine is not used for a long period of
time, the boiler must be emptied.
• Allow the appliance to cool down before
storing it.
• To prevent the build up of any scale contained
in the water, use the anti-scale as indicated
below.
> HOW TO STORE THE STEAM
CLEANER
(fig. H)
• The cable may be wound around the two hooks
on the back.