Levelling The Refrigerator; Setting Up The Refrigerator - Samsung RB28F Serie Manual Del Usuario

LEVELLING THE REFRIGERATOR

If the front of the appliance is slightly higher than
the rear, the door can be opened and closed more
easily.
Case 1) The appliance tilts down to the left.
Turn the left adjusting leg in the direction of the
arrow until the appliance is level.
Case 2) The appliance tilts down to the right.
Turn the right adjusting leg in the direction of the
arrow until the appliance is level.
< Case1 >
18_ setting up
< Case2 >

SETTING UP THE REFRIGERATOR

Now that you have your new refrigerator installed
and in place, you are ready to set up and enjoy the
full features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
If not, first check the power supply and electricity
source or try the troubleshooting section at the
back of this user guide.
If you have any further questions, contact your
Samsung Electronics service center.
1. Place the refrigerator in an appropriate location
with reasonable clearance between the wall
and the refrigerator.
Refer to installation instructions in this manual.
2. Before using the refrigerator please remove the
shelf corner covers shown on below figure.
(The covers are used to secure your refrigerator
during transportation).
3. Once the refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
4. Set the temperature control to the coldest
temperature and wait for an hour.
The freezer should get slightly chilled and the
motor should run smoothly.
5. After powering the refrigerator, it will take a few
hours to reach the appropriate temperature.
Once the refrigerator temperature is sufficiently
cool, you can store food and drink in the
refrigerator.
After powering the refrigerator, the alarm
will sound. Press Freezer or Fridge button.
(Only for Coolselect zone funtion model )
Refer to on page 19 "Using the control
Panel".