Attaching Accessories - Holmatro CT 5111 Manual De Instrucciones

5.8

Attaching accessories

5.8.1 Pulling attachments and pull chain set
Pulling attachments make it possible to use a combi tool for pulling. The pulling attachments must be
put on the blades. The pulling attachments may only be used in combination with the corresponding pull
chain set. These pulling chains consist of two parts, each with a shortening hook that only grabs the
chain. The chains are 1.5 m and 3 m long respectively.
WARNING
Hoisting is not permitted with these accessories.
The pulling accessories are intended solely for the horizontal movement of loads.
CAUTION
Check what the load is doing and make sure that it is always supported.
Make sure that the tool can move freely during pulling and always remains in a straight line
between both pulling attachments.
5.8.2 CT 5117
Refer to Fig. 11
• Make sure that the blades are slightly open.
• Slide the latch (A) towards the end of the pulling tip.
• Place the pulling adapter (B) over the spreading tip (C).
• Release the latch (A) so that the pulling tip is locked on the spreading tip.
5.8.3 CT 5160
Refer to Fig. 10
• Make sure that the blades are slightly open.
• Push (A) and pull (B) the pin out untill it locks.
• Remove the spreading tips from the blades (C).
Refer to Fig. 4
• Place the pulling adapters over the blades.
• Push pins in completely untill they lock into the position as shown.
5.9 Folding the carrying handle (Fig. 14)
• Move the carrying handle locking bar (11) upwards (2).
• Fold the carrying handle close to a preferred position, release the locking bar (11) and rotate the
carrying handle until it locks.
5.10 Rotating the carrying handle (Fig. 14)
• Push the carrying handle locking knob (4) inwards.
• Rotate the carrying handle close to a preferred position, release the locking knob (4) and rotate the
carrying handle until it locks.
CT51** (RH)(ST) 916.001.554_004
EN
41