Holmatro CT 5111 Manual De Instrucciones página 44

EN
6.7 Pulling
NOTICE
Not all tools have been designed for pulling. See section 3.3 for the tools that can be used
for pulling.
WARNING
The pulling accessories are intended solely for the horizontal movement of loads.
Make sure the lock pins stay locked.
Hoisting is not permitted with these accessories.
WARNING
Make sure that the load is always supported from underneath. Continuously check the
behaviour of the load. Make sure that the tool can move freely during pulling and always
remains in a straight line between both pulling attachments.
• Fully open the blades.
• Make sure the openings of the shortening hooks do not point down.
• Attach the pulling chains to the objects so that they cannot slip off.
• Pull the chains tight and hook them to the pulling attachments.
• Close the blades.
6.8 During use
6.8.1 Switching tools and/or hoses
The actions for switching tools or hoses during use are described chapter 5.
6.9 After use
6.9.1 Shut down
• Close the spreading arms with the spreading tips slightly opened so that the tool can be stored
without pressure.
• Switch the pump off.
• Disconnect the hydraulic hose(s) from the tool and the pump. See section 5.4.1.
6.9.2 Inspection
• Check the system for completeness, leaks and damage. Do not use the system if it leaks or is
damaged and contact the Holmatro dealer.
• Check the accessories for completeness and damage. Replace the accessory if the damage is
considerable.
• Check the operation of the deadman's handle; it must return to the neutral position.
• Check the attachment of the carrying handle; it must be firmly fastened.
6.9.3 Cleaning and storage
• Clean the tool and any accessories before storage.
• Clean the couplers and the dust caps. Make sure that the dust caps are installed.
• Dry the tool if it was used in wet conditions. Apply a thin coat of preservative oil to the external steel
parts.
• Store the tool in a dry and well-ventilated area.
44 916.001.554_004 CT51** (RH)(ST)