Shimano TLD-2SPEED Serie Manual Del Usuario página 19

1. When removing the cooling shield remember that it unscrews in a clockwise
direction.
2. When replacing the shield, be sure to screw it down tightly. We recommend
that you tighten the shield very tightly, as it secures the edges of the drag
washer. Loose installation will cause a jerky drag, so please be sure to follow
these simple instructions.
3. Keep the drag washer itself clean, dry, and free of all foreign matter while your
reel is disassembled.
4. Inspect the drag surface material for a thin film of drag grease. If a
reapplication is needed, use only Shimano's approved drag grease to ensure
the utmost performance of your reel's drag system.
5. Finally, care should be exercised when re-installing the screws that are
anchored in the graphite body. They should not be over-tightened. Only a mild
tightening pressure is necessary to secure them. Heavy pressure such as
used for tightening a nut and bolt may result in stripping the threads in the reel
body. Should this occur, oversize screws are available from Shimano or our
warranty centers.
By following these simple instructions, you should be able to perform basic service
on your reels with no problems.
professional services whenever possible. This is the best way to care for any
precision product.
However, we do continue to recommend
19