Press
.
Press and hold
again for 3 seconds.
The
key starts flashing.
Press and hold
: the digits in the cooking area indicate
Hold
and start pressing the digit of the cooking areas in clockwise order starting from the left front one.
The rear left digit alternately indicates
a number which depends on the parameters indicated in the selection.
Select a number on the power bar to access the settings menu and enter a value.
See the following table for the specifications:
Description
Menu code
Key sound volume control menu.
U2
U3
Countdown beeper volume control menu. 0 - Sound disabled
Display brightness level control menu.
U4
Countdown display control menu.
U5
Pan detection menu.
U6
Countdown end management menu.
U7
Menu to activate Hob-Hood Coupling.
U9
Once the correct value has been entered, confirm by touching and holding
To exit the menu without saving, press
If no operation is carried out the user menu will close after 1 minute.
14
.
2
1
and a number from 2 to 9 indicating the type of menu. The front left digit indicates
Value
0 - Sound disabled
1 - Min.
3 - Max.
1 - Min.
3 - Max.
0 - Max.
9 - Min.
0 - Countdown display disabled
1 - Countdown display enabled
0 - Enabled
1 - Disabled
0 - Continuous flashing and shut-down
1 - Ten flashes and shut-down
2 - One flash and shut-down
0 - Hob-Hood Coupling disabled.
1 - Activate Hob-Hood Coupling procedure. The display shows an
animation.
CAUTION: once the procedure has been activated, refer to the
hood manual and check that the K-Link Coupling procedure has
been activated. The coupling procedure takes 2 minutes.
.
3
4
for 2 seconds.