Technical Parameters - Elko iNels EMDC-64M Manual Del Usuario

Technical parameters

Power supply
Supply voltage /
Rated current:
DALI power supply:
Dissipated power:
Communication
Input interface:
Output interface:
Indication
Power supply:
Error surge or short DALI:
Indication of unit status:
Operating conditions
Relative humidity:
Operating temperature:
Storage temperature:
Protection degree:
Control device purpose:
Control device construction:
Characteristic of automatic action:
Overvoltage category:
Pollution degree:
Operating position:
Installation:
Implementation:
Dimension and weight
Dimension:
Weight:
TECHNICAL SUPPORT | E-mail: support@inels.com | Mobil: +420 778 427 366 | Tel.: +420 573 514 276, +420 573 514 211 | Fax: +420 573 514 227 | www.inels.com
Made in Czech Republic
EMDC-64M
AC 230 V (50 - 60 Hz),
-15 / +10 % / max. 100 mA
16 V, 250 mA
max. 3 W
EBM BUS (RS485 communication)
DALI (max. 64 ballasts)
DMX (max. 32 receivers, with repeator to 64)
green LED Un
illuminated red LED ERR
LED DALI/DMX (see iNELS installation handbook)
max. 80 %
-20 .. +55 °C
-30 .. +70 °C
IP20 device, IP40 mounitg in the switchboard
operating control device
individual control device
2.5 kV
II.
2
vertical
into switchboard on DIN rail EN60715
3-MODULLE
90 x 52 x 65 mm
140 g
ELKO EP, s.r.o. | Palackého 493 | 769 01 Holešov, Všetuly | Czech republic | e-mail: elko@elkoep.com
Warning
Before the device is installed and operated, read this instruction manual carefully and with full
understanding and Installation Guide System iNELS3. The instruction manual is designated for
mounting the device and for the user of such device. It has to be attached to electro-installation
documentation. The instruction manual can be also found on a web site www.inels.com. Attention,
danger of injury by electrical current! Mounting and connection can be done only by a professional
with an adequate electrical qualifi cation, and all has to be done while observing valid regulations.
Do not touch parts of the device that are energized. Danger of life-threat! While mounting, ser-
vicing, executing any changes, and repairing it is essential to observe safety regulations, norms,
directives and special regulations for working with electrical equipment. Before you start work-
ing with the device, it is essential to have all wires, connected parts, and terminals de-energized.
This instruction manual contains only general directions which need to be applied in a particular
installation. In the course of inspections and maintenance, always check (while de-energized) if
terminals are tightened.
2/2