GreenWorks CD24B00 Manual Del Propietário página 11

OPERATION
CHANGING CLUTCH SETTINGS
Fig. 4
W A R N I N G
Do not hold the chuck with one hand and use the power of the drill to tighten the chuck jaws on the drill bit. The chuck
body could slip in your hand, or your hand could slip and come in contact with the rotating drill bit. This could cause an
accident resulting in serious personal injury.
TWO-SPEED GEAR TRAIN (HI-LO)
Fig. 5
Two-speed gear train
The drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located
on top of the drill to select either LO (1) or HI (2) speed. When using drill in the LO (1) speed range, speed will
decrease and unit will have more power and torque. When using drill in the HI (2) speed range, speed will increase
and unit will have less power and torque. Use LO (1) speed for high power and torque applications and HI (2) speed
for fast drilling or driving applications.
INSTALLING/REMOVING BITS
Fig. 6
To loosen the bit
Torque adjustment ring
To tighten the bit
A
B
LO speed
HI speed
Fig. 7
WRONG / INCORRECT
FORM
11
A. The direction to decrease torque
B. The direction to increase torque