Maintenance - GreenWorks CD24B00 Manual Del Propietário

Taladro inalámbrico de iones de litio de 1/2” (13mm)
Ocultar thumbs Ver también para CD24B00:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE

W A R N I N G
When servicing, use only identical replacement parts. Use of any other parts could create a hazard or cause product
damage.
W A R N I N G
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects
being thrown into your eyes resulting in possible serious injury.
W A R N I N G
To avoid serious personal injury, always remove the battery pack from the product when cleaning or performing any
maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
W A R N I N G
with plastic parts. Chemicals can damage, weaken or destroy plastic which could result in serious personal injury.
W A R N I N G
Upon removal, cover the battery pack's terminals with heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its components. Lithium-ion and nickel-cadmium batteries must be recycled
or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may
CHUCK REMOVAL
The chuck may be removed and replaced by a new one.
■ Remove the battery pack.
■ Lock the switch trigger by placing the direction of rotation selector in center position.
■ Insert a 5/16 in. or larger hex key into the chuck of the drill and tighten the chuck jaws securely.
■ Tap the hex key sharply with a mallet in a clockwise direction. This will loosen the screw in the chuck for easy
removal.
■ Open the chuck jaws and remove the hex key. Using a screwdriver, remove the chuck screw by turning it in a
clockwise direction.
NOTE: The chuck screw has left hand threads.
Insert the hex key into the chuck and tighten the chuck jaws securely. Tap sharply with a mallet in a counterclock -
wise direction. This will loosen the chuck on the spindle. It can now be unscrewed by hand.
TO RETIGHTEN A LOOSE CHUCK
The chuck may become loose on the spindle and develop a wobble. Also, the chuck screw may become loose, causing
the chuck jaws to bind and prevent them from closing.
To tighten:
■ Remove the battery pack.
■ Lock the switch trigger by placing the direction of rotation selector in the center position.
■ Open the chuck jaws.
■ Insert the hex key into the chuck and tighten the chuck jaws securely. Tap the hex key sharply with a mallet in a
clockwise direction. This will tighten the chuck on the spindle.
■ Open the chuck jaws and remove the hex key.
■ Tighten the chuck screw.
13
.

Publicidad

Tabla de contenido
loading

Tabla de contenido