Installation; Contents Of The Kit; Equipment Required; Installation Recommendations - SOMFY Heating Modulis Ramp RTS Manual De Instrucciones

Heating Modulis RTS Ramp

3. Installation

3.1 Contents of the kit

a. Heating Modulis RTS Ramp
b. Support bracket x 2
c. Pivoting joint x 2
d. "T" support x 2

3.2 Equipment required

- Drill,
- Ø 6 mm drill bit
- 11 mm flat spanner
- Hammer
- 2 mm Allen key

3.3 Installation recommendations

Note: The Heating Modulis RTS Ramp must be installed in a location sheltered from bad weather,
and out of the reach of children.
- Never install the Heating Modulis RTS Ramp near any metal surfaces as this may reduce the
radio range.
- Do not install the equipment close to any flammable objects, such as curtains, etc.
- If the Heating Modulis RTS Ramp is placed under an awning, ensure that the fabric of the awning
is at the recommended distance from the heater when the awning is both open and closed.
- Check the radio range before fitting the Heating Modulis RTS Ramp .
- The radio range may be limited by radio appliance control standards.
- If the equipment is installed outdoors, ensure that the opening of the heater panel with its protec-
tive grille is not facing upwards.
- Do not touch the Heating Modulis RTS Ramp while it is on and while it is cooling down.

3.4 Safety distances

Caution! Avoid installing the equipment close to plug sockets, distribu-
tion units, electrical lines or switches.
• Minimum distance (Y) between a Heating Modulis RTS Ramp and a
radio control point:
Y = 30 cm
• Minimum distance (Z) between two Heating Modulis RTS Ramps:
Z = 20 cm.
Operating range (A)
Distance from the wall (B)
Distance from the wall (C)
Distance from the plug socket (D)
Distance from the ceiling or awning (E)
Minimum distance from the ground (F)
Minimum distance from a flammable object (e.g. awning fabric)
Vertical installation prohibited (G)

3.5 Installing the Heating Modulis RTS Ramp

Caution! IR halogen lamps are sensitive to substances which contain
sodium. Avoid direct contact with the skin (e.g. do not touch) as this
risks reducing the service life of the heating tube.
Caution! Before installing the Heating Modulis RTS Ramp, ensure that
the safety distances detailed in the "Safety distances" section have
been followed.
Caution: The Heating Modulis RTS Ramp has 3 grooves on the back
enabling it to be positioned in 3 different ways.
Note: The pivoting joints (c) can be used to further incline the Heating
Modulis RTS Ramp by a maximum of 90°.
18
5061611X02_HMR_Ramp_RTS.indb 18
e. Allen key x 4
f. Plug x 2
g. Screw x 2
h. Headless screw x 4
90°
300 mm
350 mm
100 mm
300 mm
1800 mm
300 mm
Copyright © 2008 Somfy SAS. All rights reserved.
Installation guide
a
b e
f
c
g
d
h
Z
Y
Ceiling or awning
E
A
B D
F
Floor
Ceiling
B D
A
C F
Floor
G
90° max.
25/05/09 18:40:48