Bosch Conettix ITS-300GSM Manual Del Instalacion página 6

6 EN
Programming via SIM Card
In the case of transparent transmission (A1), no programming is necessary for standard applications. For
SMS transmission, the number of the SMS receiver must by programmed. Programming is done via entries
in the phone book of the SIM card. Here, the value to be programmed is saved as a number (e.g.
491601234567) with a name (e.g. S4) on the storage slot (e.g. 4) in accordance with the table below.
Important: The ITS-300GSM generates a standard programming on the SIM card if no valid entries are
found there. The parameters can then be changed with a cell phone. To do this, insert the SIM card in the
cell phone, search for the entry to be changed in the phone book (e.g. S4) and change the number
accordingly.
Storage Name
Slot
4 S4
5 S5
6 S6
7 S7
Digit
1 Time window for recognition of phone line faults in seconds
0, 1=30s, 2=70s
2 Transmission mode: 0=according to Jumper position,
1=A1, 2=A2, 3=A1 + A2 as backup
3 Interval of test calls via GSM in hours
0=no test call, 1=12h, 2=24h, 3=168h
4 Permit calls from house phone via GSM
0=no, 1=yes (not allowed for Australia)
5 Adjust GSM Audio Level* (to receiver)
0=Standard (3), 1=low ... 9=high
6 Adjust GSM Audio Level* (from receiver)
0=Standard (3), 1=low ... 9=high
7 Number of PBX prefix digits – skipped when dialing via GSM
0=none, 1=1 digit, 2=2 digits
8 Switch to GSM if a manipulated phone line is detected
0, 1=no, 2=yes
9 Transmission of phone line fault/restore via GSM
0=no, 1=yes
* Important: Adjustment of Audio Level only with transmission faults via A1 (Expert Option)
Bosch Security Systems
Phone Number (max. 15 digits)
international dialing code without
zeroes (e.g. 491601234567)
(Standard: 000000000000000)
4 digits (Standard: 0000)
9 digits (Standard:000000000)
Parameters
ITS-300GSM Installation Manual
Number
Number of the SMS
receiver
Number for return
SMS after SMS
programming
SMS ID Number
Parameters (see
separate table)
Transmission
Route Affected
(A2) (B)
Optional for (C)
Optional for
(A1) (A2) (B)
Transmission
Route Affected
(A1) (A2)
F.01U.522.651 I A2 I 2006-06
(B)
(4)
(B)
(A1)
(A1)
(A1)
(A1)
(4)
(B)