Important - Hoover Power Scrub Elite Manual Del Usuario

IMPORTANT

!
Be sure to replace the Quick Spout Pour Cap to
ensure proper suction.
IMPORTANT
!
Regarding Dirty Water Tank Lid: For full suction it is
important that the Dirty Water Tank Lid is securely
in place. If misplaced, poor to no suction will result
(see Figs. E,F, G).
IMPORTANT
!
For full suction, it is important that the Dirty Water
Tank is properly secured before cleaning.
Continue using dry strokes until little
!
water is visible passing through the
nozzle.
For best results, Hoover recommends
rinsing carpet with water only. This
removes residual carpet cleaning solution.
!
Fill Solution Tank with water and repeat.
For heavily soiled areas, repeat. Avoid
saturating carpet.
NOTE: Empty Dirty Water Tank when the
motor sound becomes higher pitched and
there is a loss in suction (see "Automatic
!
shut-off"). You will also see the float rise
and shut off suction at the same time.
NOTE: It is best to alternate wet and dry
strokes as described above. See cleaning
modes section to choose best cleaning
mode for desired results.
CAUTION
! !
Do not clean over floor electrical
outlets. Water will drip from the
brushes and underside of the product
after use and may puddle. To avoid
damage to wood and laminate flooring
and to avoid potential slip hazard,
after use (a) do not leave the product
on wood and laminate surfaces and
move to a hard surface and (b) place
unit on an absorbent material
(such as a towel) to soak up drips.
12