Equipment Required - InSinkErator 2200 Serie El Manual Del Propietario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

We are delighted that you have chosen the InSinkErator

to be a part of your home. This unique appliance will save you time and effort in the

kitchen, and you'll enjoy discovering new uses for it each day. That's exactly why

millions of people are now using an InSinkErator Instant Hot Water Dispenser.

We are confident that by following our step-by-step instructions, you'll soon be enjoying

the convenience of instant hot water.

WHAT YOU SHOULD KNOW BEFORE YOU BEGIN

I I

For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing

or using this instant hot water dispenser.

I I

This particular unit is not intended for commercial use.

I I

Make sure that all electrical wiring and connections conform to local codes.

I I

A standard 120-volt grounded electrical outlet is required under the sink for the dispenser's electrical power.

I I

The wall outlet powering your dispenser must have power supplied to it continuously.

I I

This outlet must be fused and should not be controlled by the same wall switch that operates the

disposer, unless you have a SinkTop Switch

I I

It is recommended that a dedicated control valve be installed on the cold water line supplying water

to this system.

I I

If you suspect elevated levels of chlorine in your water, it is recommended to use our water

filtration system.

I I

The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa).

If it does, this will prevent your unit from operating properly.

I I

Moving parts inside the tank causing a rattling noise is normal.

WHAT YOU NEED TO GET STARTED