Domo DO912K Manual De Instrucciones página 37

Ocultar thumbs Ver también para DO912K:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
·
Wipe the door seal with clear water only and then wipe dry thoroughly.
·
After cleaning reconnect and adjust the temperature control knob as desired.
·
Put the food back into the appliance.
DEFROSTING
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or
hoarfrost form at the back of the refrigerator. This is normal. It
is not necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into the
condensation channel and is conveyed to the cooling from where
it evaporates.
Note: Keep the condensation channel and drainage hole clean, so
that the condensation can run out.
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble shooting guide for
a possible solution.
Does not work
·
Check connection of power cord to power source.
·
Plug in unit
·
Use proper voltage.
Cools too frequently
·
Check temperature setting and adjust as needed.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and MINIMIZE door openings.
·
Do not place unit close to heat sources Or direct sunlight.
Intemal temperature not cold enough
·
Check connection of power cord to Power source.
·
Plug in unit
·
Check setting and adjust as needed.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and MINMIZE, door openings.
·
Allow room for airto circulate around unit..
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
www.domo-elektro.be
37
DO912K

Publicidad

Tabla de contenido
loading

Tabla de contenido