Sennheiser Esfera SPB 8000 Instrucciones De Uso página 25

Connecting the SPB 8000 to the mains power supply/
Connecting the SPB 8000 to the mains power supply/
disconnecting it from the mains power supply
CAUTION
Damage to the SPB 8000 and danger of material damage due to an unsuitable
power supply!
If the display of the current operating voltage
you connect the SPB 8000 to an unsuitable power supply, this can cause damage
to the device or material damage.
Always make sure that the display of the current operating voltage
plays the correct voltage (115 V or 230 V AC (factory default setting)).
If necessary, change the voltage as described below.
Always ensure a reliable mains ground connection of the SPB 8000 – espe-
cially when you are using multi-outlet power strips or extension cables.
To adapt the SPB 8000 to the available mains voltage:
Pull out the mains cable from the IEC mains socket 9.
Set the ON/OFF switch
Make sure that the display of the current operating voltage
If necessary, change the voltage as shown:
To connect the SPB 8000 to the mains power supply and switch it on:
Plug the mains cable to the IEC mains socket 9.
Plug the mains connector into the wall socket.
Set the ON/OFF switch
The Power display
To completely switch off the SPB 8000 and disconnect it from the mains power supply:
Set the ON/OFF switch
Pull out the mains connector from the wall socket.
8
to position "0".
8
to position "1".
J
lights up red.
8
to position "0".
7
displays a wrong voltage or if
7
displays the correct voltage.
SPB
7
dis-
8000 | 7