Cleaning And Maintaining The Spb 8000; Restarting The Spb 8000 - Sennheiser Esfera SPB 8000 Instrucciones De Uso

Cleaning and maintaining the SPB 8000

"Pattern" window
Setting
Preset 1–4
Front Focus &
Surround Focus
Rotation
Surround Delay [ms]
Surround Low Pass [kHz] Sets the upper frequency limit of the surround channels
Output Gains
Compressor/Limiter
Threshold
Make up gain
Limiter
Ratio
LFE Low Pass Filter
Windshield High Boost
Cleaning and maintaining the SPB 8000
CAUTION
Liquids can damage the electronics of the product!
Liquids entering the housing of the products can cause a short-circuit and damage the
electronics.
Keep all liquids away from the product.
Do not use any solvents or cleansing agents.
Disconnect the product from the mains power supply before cleaning.
Only use a soft, dry cloth to clean the product.

Restarting the SPB 8000

Simultaneously press the
Explanation
Changes between the presets
Sets the auditory impression...
• for the front output channels L, C and R
(Front Focus, see cover, diagram A)
• for the rear output channels LS and RS
(Surround Focus, see cover, diagram B)
Simulates a rotation of the SPM 8000 stereo microphone
Sets the delay of the rear output channels
Sets the level of the output channels
See cover, diagram C
Sets the threshold of the compressor/limiter
Compensates for level losses caused by the compressor
Activates the limiter
Adjusts the compression ratio
Adjusts the LFE Low Pass Filter
Compensates for the treble attenuation caused by the "hairy"
cover of the SPM 8000
Comp + Preset 1 + Preset 4 buttons on the SPB 8000.
SPB 8000 | 13