GHP Group Dyna-Glo EG10000DH Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
4. DOWN Control Button:
This button is used to decrease temperature or timer settiing. It adjusts the
temperature range between 20°C--35°C(68°F--95°F) in 2°F (/1°C) increments.
5. UP Control Button:
This button is increasing temperature or timer setting. It adjusts the
temperature range between 20°C--35°C (68°F--95°F) in 2°F (/1°C)
increments.
6. Timer Button:
This button controls the Timer ON/OFF and 8 settings from 1hour to 8
hours. When the Timer is first turned on, it will come on at the shortest time
setting (1hour). Each time the Timer button is pressed, the time increases
by 1 hour, up to the longest setting (8 hours). Once the set time expires, all
garage heaters functions will be automatically turn off.
7. Fahrenheit/Celsius Button:
REMOTE:
This button displays F (Fahrenheit) or C (Celsius) depending on how the
temperature mode is set. When the garage heater is turned on, the
Fahrenheit (F) temperature will be displayed.
GARAGE HEATER :
To switch from Fahrenheit to Celsius, or vise-versa, when the garage
heater is ON, hold HEATER CONTROL button for 5 seconds. Unless
power to the unit has been interrupted, the garage heater will remember
the last temperature mode setting will start at that setting,
ADJUSTING AIR FLOW DIRECTION
1. To turn the unit when it has been installed with a single lag bolt (as shown in
figure 4a), simply turn the entire heater as needed. The unit cannot be turned
horizontally if it has been installed with 2 lag bolts.
2. To tilt the unit vertically, loosen the bracket screws (see Figure 5 on page 6).
12