Skil 2810 Instrucciones De Funcionamiento Y Seguridad página 7

SM 2610948764 04-07
INSTALLING AND REMOVING
ACCESSORIES
Disconnect battery pack
!
WARNING
from tool or place the
switch in the locked or off position before
making any assembly, adjustments or
changing accessories.
1. To install, push desired accessory
completely into dust canister (Fig. 2).
To remove, simply pull out of dust canister.
SLIDE "ON/OFF" SWITCH
Your tool can be switched "ON" by the slide
switch located on top of the motor housing.
TO TURN TOOL "ON" slide the switch
forward.
TO TURN TOOL "OFF" slide the switch
backward.
EMPTYING THE DUST CANISTER
1. Depress dust canister release button, and
remove the dust canister (Fig. 1).
2. Pull filter seal completely out of dust
canister and empty dust canister (Fig. 1).
3. Slide filter out of filter seal and tap dust out
of filter (Fig. 3).
FIG. 3
FILTER
BATTERY CHARGED CONDITION
INDICATOR
The battery is equipped with a charged
condition indicator (Fig.1). The indicator
lights shows the charged condition of the
battery during the working process.
By pressing the battery fuel indicator button,
the charged condition can also be checked
when the battery is removed or when the
machine is not in use.
• • • When all three lights are illuminated,
this indicates the battery pack is fully
charged.
4/25/07 9:02 AM
Assembly
Operating Instructions
FILTER
SEAL
Page 7
DUST
CANISTER
ACCESSORY
4. Slide filter back into filter seal and push
filter seal completely into dust canister
(Fig. 3).
5. Push dust canister onto housing until it
locks into place (Fig. 1).
FULL LINE INDICATOR
The full line shown on the
dust canister should be
used as an indicator
when vacuuming liquids.
This full line indicated the
maximum level for liquids
within the dust canister.
Your vacuum should
never be filled past the
full line; empty the dust
canister to avoid this situation. Maximum
water capacity is approximately 3 fluid ounces.
Do not tilt your vacuum with liquids in dust
canister.
Never use your vacuum to pick up flammable
or combustible liquids such as gasoline; motor
could ignite.
• • When only two lights illuminate, this
indicates the battery pack is partially charged.
• When only one light illuminates, this
indicates the battery pack is slightly charged.
When no lights illuminate, this indicates the
battery pack is completely discharged.
RELEASING AND INSERTING
BATTERY PACK
Release battery pack from tool by pressing
the battery release button and sliding pack
out of handle base (Fig. 1). To insert battery,
align battery and slide battery pack into tool
until it locks into position. Do not force.
-7-
FIG. 2
FULL
LINE
INDICATOR