Windhager BIOWIN 2 TOUCH Manual De Instrucciones página 19

2. Installation sequence
– Hook the cover back into place and secure by tightening the screws – Fig. 20, Fig. 21.
– Mount pedestal by screwing 3 screws into each side of the base – Fig. 22, Fig. 23.
Fig. 20 Hook cover into place
Fig. 22 Secure pedestal at the sides with 3
screws each
2.4 Connecting 2 plugs
– Open the cover on the control panel – Fig.
– Connect the provided plug with bridge to the PCB X22 (3-pin) and to the suction turbine power plug (6-pin) – Fig. 25.
Control panel
cover
Fig. 24 Open the cover on the control panel
Fig. 21
Fig. 23
24.
Fig. 25
19
Tighten screws
Secure pedestal at the sides with 3
screws each
Connect plug with bridge to PCB X22 and to
the suction turbine power plug
EN
3 x
M5 x 10