Springlane Mila Manual De Instrucciones página 28

Mila regularly. We recommend descaling
after every 50th preparation process, or
whenever you clearly notice limescale on
or in the machine. To descale, proceed as
follows:
1. Add 3 tsp baking soda into the water
container and fill it with water.
2. Start any programme with 300 ml.
3. Stop the preparation as soon as Mila
starts pumping water into the mixing
chamber (approx. 5–10 seconds) by
removing the water tank and
disconnecting Mila from the power.
Wait 1 hour.
4. Plug Mila in again and allow the
programme to run to the end.
5. Afterwards, run through two preparation
programmes without any ingredients
using a quantity of 1,000 ml each time.
Repeat the process, if required. Now,
Mila is good to go.
The warranty does not cover faults and
malfunctions of the appliance that are
the result of a lack of descaling.
Replacement
If Mila's blades get blunt after a period of
use, you can replace them yourself. Only
use original spare parts!
28
Attention! Exercise parti-
cular care when handling
the blades, also if they are dull.
There is a risk of injury!!
1. Ensure that Mila is not connected to
the power supply.
2. Use two rugged tools such as long
screwdrivers. Protect the base of the
mixing chamber, e.g. by placing several
layers of paper or a fitting piece of
silicone underneath the blades, to
prevent scratching the coating.
3. Position one tool on the back side of
the blade and slightly tilt it with the
blade exerting a bit of resistance.
4. Use the other tool to strike against the
tilted tool above the mixing chamber
to loosen the blade.