Inserting Batteries - Seac Q5 Instrucciones

INSERTING BATTERIES

• Twist the torch lens ring nut counter-clockwise.
• Insert the batteries making sure to match the polarity (+ or -).
• Pull out the lighting unit.
• Insert the batteries making sure to match the polarity (+ or -).
• Grease the sealing O-rings with a layer of silicone grease.
• Reinsert the lighting unit. This piece has an insertion position indicated by
a lengthwise groove, which must match up with a notch inside the body of
the torch (see image in Picture 1).
• Tighten the lens ring nut clockwise.
• Check that the torch switches on using the switch.
Strictly follow the polarity markings when inserting the batteries!
If the batteries are inserted incorrectly (inverted polarity), a short circuit
will be created, causing irreversible damage and a risk that the torch
could explode.
SWITCH
Your torch has a sliding magnetic switch with two positions: 100% light
output and low power setting (30% of maximum power).

WARNING

WARNING
Q5
13