Inserting Batteries - Seac R1 Instructions

The burntime shown is approximate because it depends on the quality of
the batteries used. We recommend using high quality alkaline batteries.
1.2 V rechargeable batteries commonly found on the market can also
be used. If rechargeable batteries are used we cannot guarantee the
burntime and light output shown on the technical sheet.

INSERTING BATTERIES

• Twist the torch lens ring nut counter-clockwise.
• Insert the batteries making sure to match the polarity (+ or -) shown on
the cage.
• Grease the sealing O-ring with a layer of silicone grease.
• Tighten the lens ring nut clockwise.
• Check that the torch switches on using the switch.
PRE-DIVE INSPECTION
• If your R1 torch has not been used recently, check the condition of the
batteries by ensuring that it switches on.
• Check that the body is fully closed.
• As soon as you enter the water, check that no bubbles emerge from
the body of the torch.
English
12
749-manuale Seac torcia R1-TOTALE.indd 12
Strictly abide by the polarity shown!
If the batteries are inserted incorrectly (inverted polarity), a
short circuit will be created, causing irreversible damage and a
risk that the torch could explode.

WARNING

WARNING
20/12/2012 11:07:23