Tamper Switch; Low Battery Indication; Wifi Setup - Chacon 34949 Manual De Usuario

Pet Immune PIR Motion Sensor
The Motion Sensor is designed for use on interior walls and is set to Home Mode
by default. Whenever the Sensor detects movement (while the alarm is armed) you
triggered and the Control Panel Internal Siren will sound immediately.
LED flashes once
when movement
is detected

Tamper Switch

The Tamper Switch (a black button with a silver spring at the top, located inside this
Sensor) is used to indicate an unauthorized attempt to remove its cover.
Whenever this button is released, it will trigger an alarm and the push alert will
notify you which Sensor has been triggered on tamper.

Low Battery Indication

If the LED indicator blinks once per 3 second, the battery must be replaced.

WiFi Setup

Step One: Download the App
The App can be downloaded from the App Store or Google Play by searching for
"AW1 Alarm".
Step Two: Power On
1. Remove the back cover from the Control Panel.
2. Connect the Power Adapter.
3. Set the Power Switch to "ON".
4. Wait until the WiFi Indicator starts to blink (approx. 30 seconds)
Note: The Control Panel will emit a short 'beep' every 3 seconds when powered up. After 30
Working Mode
Test Mode
The Sensor enters a 1 minute settling down period on power up, thereafter entering
into Test Mode. In Test Mode, the Sensor detects movement every 10 seconds and
emits an alarm signal every time movement is detected. Test Mode will remain
active for 3 minutes, thereafter entering into Power Saving Mode.
Note: You may also enter Test Mode by pressing the Test Button at the back of the Sensor.
Power Saving Mode
If the Sensor detects movement twice within 3 minutes the Sensor will automatically
enter into Sleep Mode and no movement will be detected. The Sensor will leave
Sleep Mode after a 3 minute period without any movement.
Case 1:
Initial start and then arm.
Sleep after detecting human movement twice.
Switch from sleep to arm.
Pairing New Accessories to the Control Panel
There are two ways of pairing Accessories to the Control Panel – manually and via
App.
Manual Pairing
To pair Accessories manually please follow the instructions below:
Remote Control and Sensors:
1. Press the Learn button at the back of the Control Panel
2. Press any button on the Remote Control or trigger the Sensor
Very Important: Please note that pressing the Tamper Switch instead of triggering
the Sensor will register it as a 24 Hour Zone.
(Optional Accessory) Wireless Siren:
1. Press the Learn Button on the Siren
2. Arm the Control Panel via the App
Pairing from the App
To pair the Accessories via App, open the AW1 Alarm App, go to 'Edit Accessories'
and follow the instructions on the screen.
Step Three: Connect the Control Panel to the Router
Important: AW1 does not support WiFi of 5GHz band, If dual-band(5GHz and
2.4GHz) router is used, make sure to connect with the 2.4GHz WiFi instead of the
5GHz's. Make sure your smartphone is connected to the local WiFi network and
then follow the steps in the App to connect the AW1 Control Panel to the Router.
1. Press and hold the
Control Panel will emit one 'beep'.
2. Tap [WiFi] in the
network.
3. Return to the App and key in your WiFi name and password or open the drop
down menu to scan for all the nearby wireless networks.
4. The Control Panel will beep once, wait until the WiFi indicator and the Status
indicator stop blinking, indicating that the Control Panel has successfully connected
to the network.
status
Case 2:
Press the test button and then arm.
3 minutes later
No human movement within 3 minutes
[WiFi] Button inside the Control Panel for 3 seconds, the
[Settings] of your smartphone, and select the 'WiFi Alarm'