Vibrating Alarm - NUK Eco Control Video Display 550VD Manual Del Usuario

The setting will be stored, the menu will
be closed, and the parent unit will return
directly to monitoring mode.
The lullabies will play for the set time.
The corresponding symbol will be shown
in the status bar with a T to show that the
timer is active.
Note: After 15 seconds without any input
from you, the menu will be closed with the
settings unchanged and the parent unit will
return directly to monitoring mode.
8. To switch the timer off, select the option
OFF in this submenu.

6.12 Vibrating alarm

The parent unit is equipped with an inte-
grated vibrating alarm function. It is auto-
matically activated when you set the sound
volume to its lowest level, switching the par-
ent unit to mute (see "6.14 Mute function"
on page 71). It can also be activated if
required, e.g. for providing an additional
alarm notification function, and can be par-
ticularly helpful for the hard of hearing, in
addition to the visual information shown on
the screen and by the LEDs.
The parent unit will vibrate:
• if there is a high level of noise in the
monitored room
• when the battery charge becomes low
• if the parent unit goes out of range
• if the parent unit is unable to set up a
connection with the baby unit and/or if
the connection is interrupted
• if the temperature in the monitored room
rises above or falls below the set limits
• when a reminder alarm is signalled
• once, when the vibrating alarm is
activated
• once, when the parent unit is switched to
mute.
Note: If the parent unit is switched to mute
(see "6.14 Mute function" on page 71), the
vibrating alarm is automatically activated
and cannot be deactivated. This gives par-
ents a better chance of noticing an alarm or
warning on the device.
vibrating alarm can only be deactivated by
raising the volume setting.
Activating the vibrating alarm
To activate the vibrating alarm, proceed as
follows:
1. Press the
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the
select the Vibrating alarm menu.
The selected symbol will be shown in red.
3. Press the
menu.
ON: Vibrating alarm will be activated.
OFF: Vibrating alarm will be deactivated.
The active setting will be shown in green.
4. Use the 25 or
star in front of "ON".
At this point, you can still exit the sub-
menu by pressing the
submenu will close and you will be
returned to the previous submenu. How-
ever, to continue with your settings, con-
tinue with the next step.
5. Press the
setting.
The setting will be stored, the menu will
be closed, and the parent unit will return
directly to monitoring mode.
The corresponding symbol appears in the
status bar. The parent unit will now also
vibrate when an alarm is signalled.
Deactivating the vibrating alarm
To deactivate the vibrating alarm, proceed
as follows:
1. Press the
The menu bar with the main menu will
appear at the bottom of the screen.
2. Use the
select the Vibrating alarm menu.
70
In this case, the
button 26.
24 or 27 button to
button 26 to view the sub-
28 button to move the
button 27. The
button 26 to confirm your
button 26.
24 or 27 button to