Power On/Off - EcoxGear EcoBoulder GDI-EXBM900 Manual De Instrucciones

Operations

Power On/Off

Power On: In power off mode, press
EcoBoulder. "Power On, Ready to Connect" voice prompt will be heard.
Power Off: Press briefly to power off the EcoBoulder.
Pairing a Bluetooth Device
1. Turn on your Bluetooth device.
2. Power on EcoBoulder. "Power on, ready to connect" voice prompt
will be heard. If already powered on and not in Bluetooth mode, press
SOURCE until it is in Bluetooth mode. (If Bluetooth icon on LED screen
is not flashing, briefly press
3. Navigate to your Bluetooth device's setup screen, find ECOXGEAR
and connect. If the connection is successful, the Bluetooth icon will be
lit solid and your EcoBoulder will announce "Connection successful. "
Notes:
· If the pairing is not complete within 5 minutes, the speaker will exit the
pairing mode. You need to repeat the pairing steps again.
· After the connection is successful, if you turn the speaker off and turn it
on again, it will reconnect to the last connected device automatically.
Also, a voice prompt "Power on, ready to connect" followed by
"Connection successful" will be heard.
· Press and hold for 5 seconds to clear all pairing records.
briefly to power on the
to start pairing your device.)
Adjust the Master Volume
1. Press
2. Press and hold
continuously (volume levels are 0 to 30).
a. Press briefly to increase one volume level. Press and hold
keep increasing the volume until maximum volume level is reached.
b. Press briefly to decrease one volume level. Press and hold
keep decreasing the volume until minimum volume level is reached.
Adjust the Microphone Volume
1. Press
2. Press and hold
continuously (volume levels are 0 to 30).
a. Press briefly to increase one volume level. Press and hold
keep increasing the volume until maximum volume level is reached.
b. Press briefly to decrease one volume level. Press and hold
keep decreasing the volume until minimum volume level is reached.
Source Button
Press SOURCE briefly to cycle through the following modes:
BT (Bluetooth), FM, AM, AUX 1, or AUX 2.
Play Music (Bluetooth Mode)
After the EcoBoulder is connected to your Bluetooth device, press
briefly on the EcoBoulder to play, press
Press briefly to play previous song. Press
next song.
Press
12
briefly to adjust the speaker volume.
to adjust the speaker volume
briefly to adjust the microphone volume.
to adjust the microphone volume
again to pause.
to adjust the volume.
to
to
to
to
briefly to get the
13