Klarfit Highflyer FX2 Manual De Instrucciones página 30

EN
30
Quick start in manual mode
1. Switch on the device
2. Insert safety clip
3. Press the START key.
4. The device will start at 1 km / h. The speed (SPEED) can be adjusted with
the buttons [+] and [-].
5. Press the MODE button. The display will show the preset time: [15:00].
The time (TIME) can be adjusted between 5: 00-99: 00 minutes using the
[+] and [-] buttons.
Function of the security clip
If you pull the safety line, the engine will stop immediately. The display will
show [------] and the following signal will sound: „BI-BI-BI. " In this state, the
treadmill can only be turned off. All other functions are inactive until the
magnetic clip is placed back on the support. Afterwards, the treadmill will
switch back to standby mode and may be operated normally again.
Before resuming exercise, first check to ensure that the treadmill has power,
and then check that the safety device is intact.
If you notice abnormal conditions or sounds during exercise, you can pull the
safety line to stop the treadmill immediately. Once the safety clip has been
replaced, you may continue with training.
Music playback
MP3 music playback
Connect an MP3 player to the MP3 player socket. The audio signal wll be
automatically amplified and reproduced through the speaker.
USB music playback
Connect a USB device with MP3 files to the USB port. The device will
automatically detect the audio files and play the music. The song may be
selected by pressing the PREV and NEXT buttons. The music may be started
or stopped by pressing the START / STOP button. The volume may be adjusted
using the VOL + and VOL- buttons.