IKEA FIXA Manual De Instrucciones página 11

when it is running but not actually doing
the job, as this may significantly reduce
the exposure level over the total working
period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm,
and organizing your work patterns.
ASSEMBLY
Before any work on the machine
(e. g., maintenance, tool change,
etc.) as well as during transport and
storage, set the rota tional direction
switch to the centre posi tion.
Unintentional actuation of the On/Off
switch can lead to injuries.
Battery charging
Charging your hammer drill
When the charger is connected to the
electricity supply, the red diode on the
hammer drill lights up. The diode lights up
while the battery is being charged (13).
Under normal conditions of use the
hammer drill can be recharged several
hundred times.
ATTENTION! The recharging process
generates heat in the battery.
Note: The battery that is supplied with
the hammer drill has been charged for
test purposes only and must be fully
charged before first time use.
First read the safety instructions and then
follow the loading instructions. Insert the
charge connector (15) into the socket (13)
in the hammer drill. Then connect the
charger's transformer to the electricity
supply.
Make sure that there are no knots or
sharp bends in the cable.
The charger's transformer and the battery
have been designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers. The battery will gradually
lose its charge over a period of time, even
if the tool is not used.
The lithium-ion battery is protected
against deep discharging by the
"Electronic Cell Protection (ECP)". When
the battery is empty, the machine is
switched off by means of a protective
circuit: The inserted tool no longer
rotates.
WARNING! Do not continue
to press the On/Off switch after the
machine has been automatically
switched off. The battery can be
damaged.
WARNING! Recharge the
battery on a non-flammable surface.
Do not recharge the battery for more
than eight hours. The red diode will turn
green when the battery has been fully
loaded.
Disconnect the cable and store the
transformer in a suitable place when it is
not in use.
It is not advisable to recharge the battery
in temperatures below freezing.
When removing the battery from the
machine, actuate the On/Off switch
(6) until the battery is completely
9 9