Maintenance And Cleaning - IKEA FIXA Manual De Instrucciones

Position for drilling without impact in
wood, metal, ceramic and plastic as well
as for screwdriving
Reversing the Rotational Direction
Actuate the rotational direction switch (5)
only when the machine is at a standstill.
The rotational direction switch (5) is used
to re verse the rotational direction of the
machine. However, this is not possible
with the On/Off switch (6) actuated.
Right Rotation: For drilling and driving
in screws, push the rotational direction
switch (5) left to the stop.
Left Rotation: For loosening and
unscrewing screws and nuts, press the
rotational direction switch (5) through to
the right stop.
Switching On and Off
To start the machine, press the On/Off
switch (6) and keep it pressed.
To switch off the machine, release the On/
Off switch (6).
For low temperatures, the power tool
reaches the full hammer/impact capacity
only after a cer tain time.
Note: Sparks may be visible through
the slots in the motor housing during
operation. The sparks are a normal
reaction of the motor when in use and
are created by the components inside the
motor moving against each other. The
function of the power tool is not affected
by this. We do however recommend not
to use the power tool near any flammable
liquids, gases or dust, which the sparks
may ignite.
Setting the Speed/Impact Rate
The speed/impact rate of the switched
on pow er tool can be variably adjusted,
depending on how far the On/Off switch
(6) is pressed.
Light pressure on the On/Off switch (6)
results in low speed/impact rate. Further
pressure on the switch increases the
speed/impact rate.
Temperature Dependent Overload
Protection
When using as intended, the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 70 °C is exceeded, the
electronic control switches off the power
tool until the temperature is in the
optimum temperature range again.
Working Advice
Apply the power tool to the screw/nut
only when it is switched off. Rotating
tool inserts can slip off.

MAINTENANCE AND CLEANING

Before any work on the machine (e.g.
maintenance, tool change, etc) as
well as during transport and storage,
set the selector for rotation switch
to the centre position. Unintentional
actuation of the trigger can lead to
injuries.
For safe and proper working, always
keep the machine and ventilation
slots clean.
11 11