Connect To Power Supply; Operate W120; On/Off Button; Start Your W120 - mamibot iGLASSBOT W120 Manual Del Usuario

3. Installation

3.4 Connect to Power Supply

Plug in W120. 8
Important Notes:
Be sure your W120 is always connected to AC power supply while working. Don't
use it if the backup battery is lack of power, use it after full charging. Take off your
W120 asap, if the power supply is cut or unplugged accidently.

4. Operate W120

4.1 On/Off Button

A. Power On/Off button - Press for 2 seconds to turn on/off your W120.
B. Press the On/Off button once to start or stop the W120 when it is placed on
window.

4.2 Start Your W120

A. Press the On/Off button for 2 secondes to turn on your W120.
B. Place your W120 on glass, press again the On/Off button to start.
C. You can also start it from your remote control "START" button.
Caution: Before starting, make sure the edge of W120 is 8 cm or more away
from window frames or corners.

4.3 Stop/Pause

A. When W120 is cleaning, press On/Off
remote control to stop it.
B. When W120 is cleaning, press Pause
C. You can also start it from your remote control Start

4.4 Use of Remote Control

Automatically "Z"
Z
Type Cleaning
Automatically "N"
N
Type Cleaning
From "Z" to "N" Cleaning
Z|N
A No Use Yet
B No Use Yet
Stop Cleaning
STOP
button on the device or the Stop
button on remote control to pause/restart it.
button.
p Manual Move UP
q Manual Move Down
u Manual Move Right
t Manual Move Left
Start Cleaning
START
Choose "Z" or "N" type automatically
u Stop / Restart
8
8
button on