Publicidad
Ouvrez l'un des côtés du dispositif en insérant
un tournevis plat et en tournant doucement.
To remove cover, insert screwdriver
here and gently twist.
Abra cualquier lado de la unidad insertando un
destornillador plano y girándolo cuidadosamente.
Changing the Tamper/Changer le sabotage/Cambiar el sabotaje
Case Tamper
Coffret de sabotage
Backplate
Plaque arrière
Plaqueta posterior
Install Battery/Installez la pile/Instalarla Batería
Tamper Switch/ Interrupteur Antisabotage/ Interruptor de Sabotaje
+
External Contact Terminals
Bornes pour Contact Externe
Terminales para Contacto Externo
NOTE: Use only / utilisez seulement / use solamente:
Panasonic CR-2 or Tekcell CR-2 Lithium Battery.
Figure A
Figure D
Mount Transmitter and Magnet/Fixez le transmetteur et l'aimant/Montar el Transmisor e Imán
Reed switch on underside of PC Board (in unit).
Commutateur à lames sur la face inférieure de
la carte de circuit imprimé.
BATTERY
Conmutador de lengüeta en la parte inferior
-
PILE
de la placa del equipo (en la unidad)
BATERIA
Symbol on side of the case indicates location of reed switch
Le symbole sur le côté du coffret indique l'emplacement du commutateur à lames
El símbolo en el lateral del compartimento muestra la ubicación del conmutador de lengüeta
Figure B
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by Digital Security Controls could void your authority to use this
equipment.
This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manu-
facturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the
limits for Class B device in accordance with the specifications in Subpart "B" of Part 15 of FCC Rules, which are designed to pro-
vide reasonable protection against such interference in any residential installation. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause interference to television or radio reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures:
•
Re-orient the receiving antenna
•
Relocate the alarm control with respect to the receiver
•
Move the alarm control away from the receiver
•
Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user may
find the following booklet prepared by the FCC helpful: "How to Identify and Resolve Radio/Television Interference Problems".
This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402, Stock # 004-000-00345-4.
IC: 160A-06WS4945
The term 'IC:' before the radio certification number only signifies that Industry Canada technical specifications were met.
©2006 Digital Security Controls
Toronto, Canada • www.dsc.com
Technical Support/Centre d'aide technique/Líneas Tech: 1-800-387-3630 (Canada & US) or 905-760-3036
Printed in Canada
5/8" space maximum (1.8cm)
}
Espacement maximum de 1,8cm (5/8 pouce)
Espacio máximo de 1,8 cm (5/8")
Magnet / l'aimant
iman
29034668R001
Figure C
Publicidad
