ASROCK 775XFire-VSTA Manual De Instrucciones página 30

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6. Install the Intel(R) Matrix Storage Manager software via the CD-ROM included
with your motherboard or after downloading it from the Internet. This will add
the Intel(R) Matrix Storage Console which can be used to manage the RAID
configuration.
7. After setting up a "RAID Ready" system as the above steps, you can follow the
procedures of the next section to migrate the system to RAID 0 or RAID 1.
2.14.3
2.14.3
2.14.3
Migrating a "RAID Ready" System to RAID 0 or
Migrating a "RAID Ready" System to RAID 0 or
Migrating a "RAID Ready" System to RAID 0 or
2.14.3
2.14.3
Migrating a "RAID Ready" System to RAID 0 or
Migrating a "RAID Ready" System to RAID 0 or
RAID 1
RAID 1
RAID 1
RAID 1
RAID 1
If you have an existing "RAID Ready" system, then you can use the following
steps to perform a migration from a single non-RAID configuration to a two drive
RAID 0 or RAID 1 configuration. To prepare for this, you will need another SATA
hard drive with a capacity equal to or greater than that currently being used as the
source hard drive.
1. Physically attach one additional SATA hard drive to the SATA port not being
used. Note the serial number of the hard drive already in the system; you will
use this to select it as the source hard drive when initiating the migration.
2. Boot Windows
®
, install the Intel(R) Matrix Storage Manager software, if not
already installed, using the setup package obtained from a CD-ROM or from the
Internet. This will install the necessary Intel Storage Utility and start menu links.
3. Open the Intel Storage Utility from the Start Menu and select "Create RAID
volume from Existing Hard Drive" from the Actions menu. This will activate the
Create RAID volume from Existing Hard Drive Wizard. Click through the dialogs
as prompted. It's important to understand what will occur during the migration
process because any data on the destination hard drive will be lost.
4. Once the migration is complete, reboot the system. If you migrated to a RAID 0
volume, use Disk Management from within Windows
format the empty space created when the two hard drive capacities are
combined. You may also use third-party software to extend any existing
partitions within the RAID volume.
3 0
3 0
3 0
3 0
3 0
ASRock 775XFire-VSTA Motherboard
®
in order to partition and

Publicidad

Tabla de contenido
loading

Tabla de contenido