Adjusting The Signal Type; Inverting The Pwm Signal - Resol VBus/PWM Manual

4. Adjusting the signal type

Jumper position for
PWM signal
The jumper to the right of the terminals is used for deter-
mining whether a PWM signal or 0-10 V signal is to be used.
The jumper poles are indicated with A, B and C.
Jumper position A+B = PWM signal (factory setting)
Jumper position B+C = 0-10 V signal
Changing the signal type:
Î Pull the jumper out of the slot and insert it according
to the desired signal type.
Jumper position for
0-10 V signal

5. Inverting the PWM signal

Jumper slot for the
inversion of the
PWM signal
inverted
100
70
30
30%
DIP switches for
addressing the
signal output
normal
100% PWM %
15