Error Message; Important Notice - Resol VBus/PWM Manual

As the LED can only indicate one figure, the decimal digit is
replaced with a dot when indicating relays 10 - 16:
1 = Relay 1
2 = Relay 2
3 = Relay 3
4 = Relay 4
5 = Relay 5
6 = Relay 6
7 = Relay 7
8 = Relay 8

Error message

If an error occurs, the display flashes an error code:
a = The output addressing is faulty.
The relay addressed does not exist.
Î Address a valid relay.
f = The VBus connection is faulty.
®
Î Check the VBus cable.
®
u = The controller connected is not recognised by the
device.
Î Wait for about one minute. If the error code does not
disappear, contact the manufacturer.
9 = Relay 9
0. = Relay 10
1. = Relay 11
2. = Relay 12
3. = Relay 13
4. = Relay 14
5. = Relay 15
6. = Relay 16
8. Important note
The texts and drawings in this manual are correct to the best
of our knowledge. As faults can never be excluded, please note:
Your own calculations and plans, under consideration of the
current standards and directions should only be basis for your
projects. We do not offer a guarantee for the completeness
of the drawings and texts of this manual - they only represent
some examples. They can only be used at your own risk. No li-
ability is assumed for incorrect, incomplete or false information
and / or the resulting damages.
Note
The design and the specifications can be changed without no-
tice.
The illustrations may differ from the original product.
Imprint
This mounting- and operation manual including all parts is
copyrighted. Another use outside the copyright requires the
approval of RESOL – Elektronische Regelungen GmbH. This
especially applies for copies, translations, micro films and the
storage into electronic systems.
© RESOL – Elektronische Regelungen GmbH
17