Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation & Operation (Continued)
10. Fasten the mounting plate to the junction box in the wall with screws.
11. Hook the driver box onto the mounting plate. Allow the fixture to hang by the
hooks, to facilitate the wiring process (Figure 9).
12. Pull the wires through the hole in the mounting plate and complete the wiring
connections following the wiring diagram (See wiring diagram on page 3):
13. Replace the driver box onto the mounting plate. Ensure that the gasket around
the mounting plate fits in place. Secure the driver box to the mounting plate using
the screws on the sides of the driver box.
14. Cover the side screws with the rubber plugs.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
Publicidad
Tabla de contenido
