Changing The Batteries - bewell connect MyBabyScale Manual De Instrucciones

- If you wish to place a towel under the baby before weighing it, put
it on the scale before turning it on. Press the "on/off" button and
place the baby on the tray when "0.00" appears on the screen. The
scale automatically performs the calculation and only displays the
baby's weight (at the same time as the word "hold").
- After weighing, remove the baby at the same time as the towel. A
negative value will appear, press "tare" to reset the scale to zero for
future weight measurements.
- When the child is able to stand, replace the baby weighing tray
with the disc.
Do not use the disc to weigh a child that cannot yet stand.
Shutdown
- The device shuts down automatically after displaying the weight
(approximately one minute).
- The device can be shut down manually by pressing the "on/off" but-
ton.

3.3. CHANGING THE BATTERIES

- The battery compartment is located at the back of the device.
- When using it for the first time, insert 2 new 1.5V LR6-AA batteries
into the scale.
- When the LCD screen displays "LO", the batteries are low or used
up. Replace used batteries, taking care to observe the polarity. A
polarity error may cause damage to the device and compromise
the warranty.
- Never insert rechargeable batteries. Use single-use batteries only.
Do not mix new batteries with used batteries.
- Do not throw your used batteries out with household waste.
- Take your used batteries to a collection point.
Remove the batteries if the device is not in use for a long period, in
order to avoid any leaks that may damage the unit.
18 BewellConnect - BW-SCB1 - User Manual - 012017v1