Gear Selection; Magnet Operation - 39-D 251 - Walter Surface Technologies ICECUT 250 Manual De Instrucciones

Icecut 250 & Icecut 250P

9) GEAR SELECTION

The Icecut 250 & 250P magnetic drills are fitted with a 2 speed gearbox.
The gear is used to reduce the output speed when using larger cutters.
Slide Selector Position
High Speed /\
Low Speed \/
Slide Selector Positon Up
10) MAGNET OPERATION
1. Place the magnetic drill on the workpiece, ensuring the machine is in a stable position.
2. To turn the magnets, on rotate the activating ratchet handles as in the image seen below.
3. For positioning only, move the ratchet handles around 90°.
4. During operation always ensure the ratchet handles are set to maximum.
5. Only when the ratchet handles are rotated a full 180°, can the magnet be judged to be fully
off or on.
ONLY WHEN FULL MAGNETIC ADHESION IS JUSTIFIED BY ROTATING THE RATCHET HANDLES TO
MAXIMUM, SHOULD THE MOTOR BE POWERED ON.
Original Instructions
Level 1 Level 2
200/min 260/min
133/min
100/min
Slide Selector Positon Down
ICECUT 250P (39-D 251)
Speed Controller Setting
Level 3 Level 4
320/min 380/min
166/min 199/min
13
12-2018
Level 5 Level 6
440/min 500/min
232/min
265/min