Information Plate Symbols - Walter Surface Technologies ICECUT 250 Manual De Instrucciones

Icecut 250 & Icecut 250P

Inspect tool cords periodically and if damaged have it repaired by an authorized Walter service facility.

Inspect extension cords periodically and replace if damaged.

Keep handles dry, clean and free from oil and grease.
10. Disconnect tools from the power supply when not in use, before servicing or when changing accessories such as
cutters.
11. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on.
12. Use extension leads only intended for outdoor use when the tool is used outdoors.
13. The vibration emissions during actual use can differ from the declared total value depending on the ways in which
the tool is being used.
14. Watch what you are doing, use common sense and do not operate the tool when you are tired. Do not operate the
machine when under the influence of alcohol or any illegal substances.
15. Check damaged parts

Before further use of tool, it should be carefully checked to determine that it will operate property and
perform its intended function.

Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other
conditions that may affect its operation.

A guard or other part that is damaged should be properly repaired or replaced by an authorized service centre
unless otherwise indicated in this instruction manual.

Have defective switches replaced by authorized service centre,

Do not use the tool if the switch does no turn it on and off.
16. The use of any accessory or attachment, other than ones recommended in this instruction manual, may present a
risk of personal injury.
17. Have your machine repaired by a qualified Walter technician. This electric tool complies with the relevant safety
rules. Qualified persons using original spare parts should only carry out repairs otherwise this may result in
considerable danger to the user.
18. Never operate the machine if parts are missing or damaged.
19. Never direct jets of water or flammable liquids over the drill.
20. Operator must be physically able to handle the weight of the machine.
21. Operator should be trained in the use of the machine.

3) INFORMATION PLATE SYMBOLS

1
1
1
1
1. Refer to the user manual for operational and safety issues with regard to this machine.
2. Dispose of the machine and electrical components correctly.
3. Eye protection must be worn when operating the machine.
4. Ear defenders must be worn when operating the machine.
Original Instructions
2
2
2
3
3 4
3
6
12-2018
4
4