Manual Mode; Tare Function - Krups GX420851 Manual Del Usuario

1. Set the quantity of ground coffee using the - & + buttons until you reach the desired
weight (up to 100g). To adjust the quantity faster, simply hold the – or + button
accordingly. (fig 18)
2. Press the START/STOP
and the scale will start weighting the coffee grind on display. (fig 18)
3. Once the selected quantity has been reached, the appliance will stop automatically.
NOTE:
„ If you want to stop the appliance before grinding is complete, press the
START/STOP
again and it will continue the cycle until completion
„ If you remove the coffee ground in the container, it will reset the scale and start the cycle
over.
4. Remove the ground coffee holder, tap the container gently, remove the lid and pour the
ground coffee into the filter of the coffee maker or use a measuring spoon. (fig 17)
5. To obtain additional ground coffee, adjust the desired quantity and resume operation.
You can also empty your container and repeat the operation.
NOTE: The coffee grinder will display the last selected setting.
NOTE: If you want to use the dripper provided or another container please refer to the
TARE FUNCTION paragraph.
During the manual mode the built-in scale is deactivated. This mode is recommended for
grinding straight into portafilters for espresso extractions.
1. Press the START/STOP
time during operation until you stop. (fig 19)
2. Once the desired quantity has been reached, press again the START/STOP
to stop the operation. (fig 19)
NOTE: To obtain additional ground coffee, repeat the operating cycle. Always first
make sure that the ground coffee does not go above the maximum capacity of the
container(100g/3.55oz)
Your coffee grinder is designed to be used with the original bean container. If the original
bean container is not empty or if you are using another container, you will be notified with
the Warning indicator in the display and won't be able to start grinding until the grinder
has been tared/zeroed out.
If you want to use the dripper provided or another container, you must reset the scale using
the TARE button prior to selecting the weight and start operation.
1. Place the new recipient on the scale (fig 9)
2. Reset the unit using the TARE button. (fig 21)
3. Once the scale is reset, the Warning
WEIGHT MODE
button to start grinding. The display will flash during operation
button. To resume the operation, press the START/STOP

MANUAL MODE

button to start grinding. The display will begin counting up

TARE FUNCTION

button will turn off. (fig 22)
button
button
5