Cool Mode; Dry Mode; Fan Mode - Kenmore 407.83086 Manual De Uso Y Cuidado

IMPORTANT: After switching the unit on, the ventilator fan operates, but the compressor will
not start for approximately three minutes. Cool air wilt begin to blow once the compressor
starts, but it may take another 5 minutes to feel the effect in the room. This feature helps pro-
long the life of the compressor. Further information is available in the "Troubleshooting" sec-
tion. When adjusting the direction of the air flow, only place fingers on the left side of Air
Outlet Louvers where tab appears.
COOL MODE
• Place the unit in the room that requires cooling.
We recommend starting your unit early in the morning on warm days for maximum
effect. This unit has a self-evaporation system to eliminate water that condenses in the
unit during cooling. The exhaust hose must be connected and properly installed to cool
the room properly. See the INSTALLATION instructions on page 9-10 of this USE AND
CARE GUIDE.
• Use the MODE button on the unit control panel or remote and set to COOL. Adjust the
set temperature using the up and down buttons on the unit or - and + buttons on the
remote. The cooling temperature can be set from 61°F to 86°E.
• Using the remote control, press FAN button to adjust fan speed from Auto, Low, Med or
High.
DRY MODE
• Place the unit in the room that requires dehumidlfication.
• The exhaust hose must be connected and properly installed to dehumidify the room
properly. See the INSTALLATION instructions on page 9-10 of this USEAND CARE
GUIDE.
• Use the MODE button on the unit control panel or remote and set to DRY.
• The fan speed is set to low and cannot be ad,iusted in DRY Mode.
• The compressor will run continuously when the unit operates in DRY mode.
• There is a built-in defrost control that sensesfrost buildup on the evaporator coils. During
defrosting, the compressor will automatically turn off. The fan will continue running to
defrost the coils. Once the frost has been removed, the compressor will re-start.
NOTE: The set temperature will not appear on the unit display. The set temperature and fan
speed cannot be adjusted while operating in this mode.
FAN MODE
• Place the unit in the room that requires fanning or air circulation.
• Use the MODE button on the unit control panel or remote and set to FAN. Using the
remote control, press FAN button to adjust fan speed from Auto, Low, Med or High.
• The fan auto setting will change the fan speed to either High or Medium, depending on
the last setting of the cooling mode set temperature.
NOTE: The set temperature will not appear on the unit display and cannot be adjusted while
operating in this mode.
14