CubCadet Z-Force Lapbar Manual Del Operador página 16

7. Align the tractor with an edge of the mowed
strip and overlap approximately 3".
8. Direct the tractor on each subsequent strip
to align with a previously cut strip.
9. To prevent rutting or grooving of the turf, if
possible, change the direction that the strips
are mowed by approximately 45° for the next
and each subsequent mowing.
WARNING
Be careful when crossing gravel paths or driveways. Disengage
the PTO and raise the deck to the highest position before crossing.
Note: When stopping the tractor for any
reason while on a grass surface, always:
• Place the control levers in the
neutral/parking brake engaged
position,
• Shut engine off and remove the key.
• Doing so will minimize the possibility
of having your lawn ''browned'' by hot
exhaust from your tractor's running
engine.
Notes
16 S 3 — c
ection ontrolS
Deck Lift Lever
To raise or lower the cutting deck, depress
the button on the end of the handle and push
downward to lower the deck, or pull upward to raise
the deck, then place it in the hole best suited for
your application. To place the deck in the transport
position, lift the handle all the way up and hang
the top hook on the handle from the upper spacer
on the deck height index bracket. See Figure 3-13.
Lowest Mowing
Position
& o
peration
Transport Position/
Highest Mowing
Position
Deck Removal/
Installation Position
Figure 3-13
Note: Make certain the deck is secured and the pin
is fully inserted into the deck height index. The pin
is keyed to help keep it in place and fits into the
slotted holes on the deck height index.
Note: The deck lift handle must always be above
the pin, never hang the deck lift handle from the
pin when mowing.