Ra30-1 Temporary Roof Anchor - Sperian Miller RA15-1 Manual De Instrucciones Para El Usuario

4.3 RA30-1 Temporary Roof Anchor

Warnings and Limitations
ted by the system while in use (or provide a 2:1 safety factor).
comprised of wood members. Do not install on unsupported roof structures such as
eaves or gable overhangs. Do not install on facia boards.
63.5mm) or longer lag screws be used each time the anchor is installed. Roof anchor
must be inspected before each installation.
Fig. 3
Roof Anchor
Sheathing
Attach with
twelve (12)
16d nails
(six on
each
side).
Installation
under roof sheathing at the location where the roof anchor will be installed.
nails and screws when installing the RA30-1 roof anchor.)
WARNING: Use all twelve (12) 16d nails OR all six (6) ¼" x 2-½" (6.4mm x 63.5mm) lag
screws to attach the RA30-1 roof anchor. All nails/screws must pass through the sheath-
ing and into a support structure. If this warning is not followed, the anchorage connec-
tion will be weakened and serious injury or death could occur in the event of a fall.
WARNING: Attach to the O-ring only with a locking snap hook, locking carabiner, or other
Miller approved connector or connecting device.
Us er In stru ctio ns - Engli sh
*Drawing is for illustration purposes only.
Do not combine nails and screws when
installing the RA30-1 roof anchor. See
installation instructions.
(Drawing is for illustration purposes only -- Do not combine
Attach with six (6)
¼" x 2-½" (6.4mm
x 63.5mm) lag
screws (three on
each side).
Roof Member
-