Omega 42001 Manual De Instrucciones De Funcionamiento página 5

MAINTENANCE
Important: Use only good grade hydraulic jack oil. Avoid mixing different types of fluid and NEVER use brake fluid,
turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause premature failure of the jack and the
potential for sudden and immediate loss of load. Premium hydraulic jack oil or equivalent recommended.
Adding oil
1. With saddle fully lowered, set jack in its upright, level position. Remove oil filler plug.
2. Fill until oil is level with the oil filler plug hole, reinstall oil filler plug.
Changing oil
For best performance and longest life, replace the complete fluid supply at least once per year.
1. With saddle fully lowered, remove oil filler plug.
2. Lay the jack on its side and drain the fluid into a suitable container.
Note. Dispose of hydraulic fluid in accordance with local regulations.
3. Set jack in its level position.
Lubrication
1. A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
casters and pump assemblies move freely.
2. For air option models 42001: When used on a daily basis, air pump model should be internally lubricated before
each use. Use only good quality air tool lubricant. If no inline oiler is used, pour a teaspoon of air tool oil into the
inlet of the air supply inlet. Simply operate the jack using the air feature in order to fully distribute the oil.
Cleaning
Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily
cloth.
Note: Never use sandpaper or abrasive material on these surfaces!
Storage
When not in use, store the jack with saddle fully lowered.
TROUBLESHOOTING
Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after unloading
Poor lift performance
Jack will not lift to full extension
Fill until oil is level with the oil filler plug hole, reinstall oil filler plug.
Possible Causes
• Release valve not tightly closed
• Load is too heavy
• Release valve not tightly closed
• Hydraulic unit malfunction
• Reservoir overfilled
• Linkage binding
• Fluid level low
• Hydraulic unit malfunction
• Air trapped in the system
• Fluid level low
• Ensure release valve tightly closed
• Consider higher capacity jack
• Ensure release valve tightly closed
• Discontinue use, Contact Omega
Tech. Service
• Ensure load is removed, then drain
fluid to proper level
• Clean and lubricate moving parts
• Ensure proper fluid level
• Discontinue use, Contact Omega
Tech. Service
• Refer to bleeding instructions on
Pg. 4
• Ensure proper fluid level
5
Corrective Action