EcoxGear EcoPebble Guia Del Usuario página 10

Tabla de contenido

Publicidad

FCC Compliance Statement & Warning:
This device has been tested & found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. The device generates, uses & can radiate radio frequency energy & if
not installed & used in accordance with instructions may cause harmful interference to radio communications. There is no guarantee that interference will not
occur in a particular installation. IF this device causes interference to radio or television reception try one of these measures: reorient or relocate the receiving
antenna, increase separation between device & receiver, connect the device into an outlet on a circuit different from that to which the receiver is connected,
consult a dealer or experienced radio / TV technician for assistance. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the device and/or void the manufacturer's limited warranty.
Product Use and Protection:
Read and Follow all Instructions. Use only as intended.
The ECOXGEAR Bluetooth speaker is intended to be used indoors or outdoors and in land or water environments. The speaker has been tested to IP67
waterproofing standards, which means the speaker can be submerged in up to 3 feet of water for 30 minutes without any damage. However, the speaker is
not intended for constant underwater use.
Always make sure the cap(s) / cover(s) are clean, free from sand or debris and correctly fitted. The speaker will only meet IP67 ratings if all rubber seals,
gasket(s) and cover(s) / cap(s) are in place. If you notice a muffling of audio after submersion gently shake the unit to clear excess water. If your speaker is
exposed to salt water clean it thoroughly after use with fresh water.
The USB cables, power adapters, and the unit with an improperly fitted cap, are NOT waterproof.
To prevent fire or shock, do not attempt to charge this unit if it is wet or you suspect water has entered the unit. In this situation, please return the unit to
Grace Digital for a free assessment. If we have found that the unit has carried water we will repair or replace the unit free of charge.
SAFETY ADVISORY & WARNING:
Read and Follow all Instructions. Use only as intended.
CAUTION:
Do NOT open to repair. A qualified technician must carry out repair work.
CAUTION:
ATTENTION: Do NOT charge while the unit is wet. Towel dry the unit AND make sure all connections are dry BEFORE plugging in the charging
connector. Failure to do so may result in electrical damage to the unit and may void the warranty.
WARNING:
This product may contain chemicals listed in Proposition 65 ( www.oehha.ca.gov/prop65/prop65_list/Newlist.html )
WARNING:
ECOPEBBLE has a built-in Lithium Ion battery. The battery must NOT be used in or near an open heat source or excessive heat.
WARNING:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
ATTENTION:
Do NOT dispose of in a landfill. Contact Grace Digital at www.gracesupport.com or a certified recycling agent to dispose of the unit.
ATTENTION:
AC adapter is a device forming a part of the main plug therefore the AC adapter can always be readily disconnected from AC socket-outlet.
Botones de control y funcionamiento
EN ESPERA
ENCENDIDO/APAGADO
MANTENGA PULSADO el botón
en espera por 3-5 segundos
para encender/apagar la unidad.
Ecopebble permanece en modo en
espera cuando está apagado.
IMPORTANTE: El modo En
Espera NO funcionará cuando la
Alimentación Principal esté apagada.
El Interruptor de alimentación
principal que se encuentra en el panel
trasero debe estar encendido para
que funcione el modo En Espera.
SELECCIÓN DE PISTA /
VOLUMEN ALTAVOZ
PULSE UNA VEZ para seleccionar la
pista anterior.
MANTENGA PULSADO para reducir
el volumen.
REPRODUCIR / PAUSAR
RESPONDER
PULSE UNA VEZ para
reproducir y pausar las pistas
de audio.
SELECCIÓN DE PISTA /
VOLUMEN ALTAVOZ
PULSE UNA VEZ para seleccionar
la pista siguiente.
MANTENGA PULSADO para
aumentar el volumen.
NOTA: Algunos dispositivos
Bluetooth deben configurarse
manualmente en el nivel de audio
máximo. Su ECOPEBBLE emitirá
un pitido para indicar cuando se
ha alcanzado el volumen máximo
establecido.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gdi-egbp100-110

Tabla de contenido