Sharpening Guide - Work Sharp WS2000 Guia Del Usuario

www.worksharptools.com
the paper into a "U" (fig. 2-4) shape
so the center of the abrasive is cen-
tered on the wheel. Slowly flatten out
the abrasive from the center working
toward the outer edge of the wheel.
Adhere the slotted abrasive in the
same manner outlined above. Be sure
all the slots in the abrasive properly
align with the slots in the wheel sur-
face. This will ensure proper perfor-
mance of the Edge-Vision™ slotted
wheel during use.
3

Sharpening Guide

Read all safety warnings before operat-
ing this tool.
Chisel Sharpening
Port—
For chisels and
plane blades up to 1
STEP 1
Mount the grinding wheel onto the unit
with coarse side up.
Fig. 2-4
/ " wide
5
8
Chisel Sharpening Port
7. To install your
top tool rest,
slide the top
tool rest into
the T-slots on
the top of the
unit. Locate the
desired height,
then gently snug
the two thumb
screws. Do not
over tighten the thumbscrews, as you
can potentially stress and/or damage
the T-slots in the top casting.
8. Mount the grinding wheel to the
wheel hub and secure the wheel with
the top knob.
9. Your tool is now ready for use!
STEP 2
Flatten tool back on topside of abrasive
wheel. Lay tool down heel first onto wheel.
After flattening tool back, flip grinding
wheel over so coarse abrasive is now face
down for bevel grinding.
11